Mitsubishi MELSEC Q Series User Manual page 35

2 SYSTEM CONFIGURATION
2 - 5
(b) When performing the parameter setting with the dedicated instructions.
Applicable module
Q00JCPU
Q00CPU
Q01CPU
Q02CPU
CPU
Q02HCPU
module
Q06HCPU
Q12HCPU
Q25HCPU
Q12PHCPU
Q25PHCPU
1 See User's Manual (Function Explanation, Program Fundamentals) for the CPU
module to use.
2 Incompatible with the remote net additional mode. When the module is used,
operation cannot be guaranteed.
3 For use in the remote net additional mode, use the PLC CPU whose first
five digits of serial No. are 05032 or later.
If the incompatible PLC CPU is used, operation cannot be guaranteed.
(2) Mountable base unit
QJ61BT11N can be mounted on any of the base unit's I/O slots ( 4). However,
depending on combinations with other mounted modules and the number of
mountings, there may be cases where the power capacity is insufficient. Be sure
to consider the power capacity when mounting the module.
4 Must be inside the point number range of 1 CPU unit and network module (for remote
I/O station).
(3) Applicable software package
The software package available for the QJ61BT11N is listed below:
Manual name
GX Developer
5 The product of Version 8.03D or later is required for use in the remote net ver. 2
mode or remote net additional mode.
(4) Usable slave stations
Any of ver. 1 compatible slave stations and ver. 2 compatible slave stations is
usable.
Number of CPUs that can be mounted (
Maximum 2
Maximum 64
Maximum 64
Model name
SWnD5C-GPPW-E
MELSEC-Q
3
)
Remark
1
(
It can be
mounted only
with the Q
mode.
1
(
1
(
Remarks
Required MELSEC PLC
programming software.
5
"n" in the model name is 4 or
greater.
2 - 5
2
) ( )
3
) ( )
2
) ( )