6 PARAMETER SETTINGS
6.3.3 Local station network parameter settings
6 - 12
(1) The following describes an example of the parameter settings. See (2) for actual
settings.
(2) Set the network parameters using the following procedure.
(a) Set the "No. of boards in module " for which the network parameters are to be
set.
Default value : None
Setting range: 0 to 4 (Boards)
Example) Set 1 (Board).
(b) Set the "Start I/O No." for the local station.
Default value : None
Setting range: 0000 to 0FE0
Example) Set 0000.
(c) Set the station type using "Type".
Default value : Master station
Setting range: Master station
Example) Set to Local station.
Master station (Duplex function)
Local station
Standby master station
MELSEC-Q
6 - 12