Emerson Liebert Intellislot Unity Card User Manual page 71

SNMP v3 Enable
Enable or Disable SNMPv3.
Authentication Traps
When enabled, an Authentication Trap is sent if an SNMP host tries to access the card via SNMP, but
either the host address is not in the SNMP Access Settings or it is using the wrong Community String.
Heartbeat Trap Interval
Enable or Disable and set interval 5 minutes, 30 minutes, 1 hour, 4 hours, 8 hours, 12 hours and 24 hours.
RFC-1628 MIB
Enable or Disable support for retrieval of data from the RFC-1628 MIB objects.
Note: Required for proper operation of Liebert MultiLink
equipment.
RFC-1628 MIB Traps
Enable or Disable support for sending RFC-1628 traps.
Note: Required for proper operation of Liebert MultiLink and applies only to managed UPS equipment.
Liebert Global Products (LGP) MIB
Enable or Disable support for getting and setting data using the Liebert Global Products MIB.
LGP MIB Traps
Enable or Disable support for Liebert Global Products MIB traps.
Note: LGP traps will not be sent unless LGP MIB is enabled.
LGP MIB System Notify Trap
Enable or Disable support for the LGP System Notification trap. This is a single trap sent each time an
alarm or warning is added or removed from the conditions table. It provides a text description of the event
in a varbind of the trap message.
Note: LGP System Notify Traps will not be generated unless the LGP MIB is enabled.
SNMPv3 Engine ID Format Type
Selects method to build the engine ID. Valid values:
• MAC Address (default) = Engine ID built from the Unity card's MAC address.
• Text = Engine ID built from text entered in SNMPv3 Engine ID Text. See 3.1.3.1.1, Select SNMPv3
Engine ID Format, page 23.
SNMPv3 Engine ID Text
Text on which the engine ID is built when SNMPv3 Engine ID Format Type is Text.
Note: If this field is left blank, the engine ID is built from the Unity card's MAC address.
Editing the Liebert IntelliSlot Unity Card Configuration
®
and applies only to managed UPS
®
61 Liebert IntelliSlot
™
™
Unity Card User Manual