Class B Equipment; Declaration Of Conformity For Products Marked With Fcc Logo-United States Only - HP storageworks 2/32 Installation Manual

Class B Equipment

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
■
■
■
■
Declaration of Conformity for Products Marked with FCC Logo—United
States Only
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
For questions regarding your product, refer to http://www.hp.com.
For questions regarding this FCC declaration, contact:
Hewlett-Packard Company
Product Regulations Manager
3000 Hanover St.
Palo Alto, CA 94304
Or call 1-650-857-1501
To identify this product, refer to the part, Regulatory Model Number, or product
number found on the product.
Edge Switch 2/32 Installation Guide
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio or television technician for help.
Regulatory Compliance Notices
115