Configure Switch Network Information - HP storageworks 2/32 Installation Manual

Installing and Configuring the Edge Switch 2/32

Configure Switch Network Information

The Edge Switch 2/32 is delivered with the following default network addresses:
■
Note:
on the switch motherboard. If an event occurs that indicates the CTP as faulty,
replacement of the switch assembly is required.
■
Note:
the switch shipped from the factory, resetting the configuration will return this feature to
the factory default of only 16 ports enabled. You must re-enable the additional ports
using the Configure Feature Key dialog box (see
■
38
MAC address—the media access control (MAC) address is programmed into
FLASH memory on the CTP card at the time of manufacture. The MAC
address is unique for each switch, and should not be changed. The address is
in xx.xx.xx.xx.xx.xx format, where xx is a hexadecimal pair.
References to the CTP in this manual are to the control processor logic contained
IP address—the factory preset default internet protocol (IP) address is
10.1.1.10. The default IP address is also 10.1.1.10.
If Reset Configuration is selected from the Product Manager application, the
switch resets to the default address of 10.1.1.10.
If multiple switches are installed on the same LAN, each switch (and the
HAFM server) must have a unique IP address. One switch can use the
factory-set address, but the addresses of the remaining switches must be
changed.
If you have enabled additional port function with the HP Flexport feature since
WARNING: This operation resets all configuration including any optional
features that have been installed. You will need to re-enter your feature key to
enable all optional features after resetting the configuration parameters.
Subnet mask—the default subnet mask is 255.0.0.0. If the switch is installed
on a complex public LAN with one or more routers, the address may require
change.
"Configure Feature Key" on page 78).
Edge Switch 2/32 Installation Guide