Configure User Rights - HP storageworks 2/32 Installation Manual

3. Click Activate to save the information. The message Your changes to

Configure User Rights

Perform this procedure to configure the administrator-level and operator-level
passwords used to access the Embedded Web Server interface through the
Username and Password Required dialog box.
To configure passwords:
1. At the Configure window, click the User Rights tab. The User Rights page
2. For the Administrator set of data fields:
Edge Switch 2/32 Installation Guide
c. Type the IP address or DNS host name of the trap recipient (SNMP
management workstation) in the associated Trap Recipient field. Use 64
alphanumeric characters or less. It is recommended the IP address be
used.
d. The default user datagram protocol (UDP) port number for trap recipients
is 162. To override this port number; click the Advanced option. The
dialog box expands to show a UDP Port Number column. Type a
decimal port number in the associated UDP Port Number field to
override the default.
the SNMP configuration have been successfully
activated displays.
displays.
a. Type the administrator user name (as specified by the customer's network
administrator) in the New User Name field. Use 16 alphanumeric
characters or less.
b. Type the administrator password (as specified by the customer's network
administrator) in the New Password field. Use 16 alphanumeric
characters or less.
c. Type the administrator password again in the Confirm New Password
field (Figure 44).
Using the Embedded Web Server
101