Enable Embedded Web Server; Enable Telnet; Connect Cables To Fibre Channel Ports - HP storageworks 2/32 Installation Manual

Enable Embedded Web Server

Use the following steps to enable EWS:
1. At the Hardware View page, choose Configure > Enable Web Server.
2. Choose Enable Web Server again to remove the check mark and disable the
For complete information on using the EWS, refer to the HP StorageWorks
Embedded Web Server User Guide.

Enable Telnet

Use the following steps to enable Telnet:
1. At the Hardware View, choose Configure > Enable Telnet. Choosing
2. Choose Enable Telnet again to remove the check mark and disable Telnet

Connect Cables to Fibre Channel Ports

Perform this task to connect devices to the switch. To cable Fibre Channel ports:
1. Route single mode or multimode fiber-optic cables (depending on the type of
2. Connect device cables to small form factor pluggable (SFP) transceivers. Start
3. Perform one of the following:
4. Set the switch online.
Edge Switch 2/32 Installation Guide
Choosing Enable Web Server automatically places a check mark in the
check box.
EWS interface. When disabled, remote users cannot access the interface.
Enable Telnet automatically places a check mark in the check box.
access. When disabled, remote users cannot access the switch through Telnet.
SFP pluggable optic transceivers installed) from customer-specified devices
to ports at the front of the switch.
with port 0 and continue sequentially to the left through port 31.
a. If the switch is installed on a table or desk top, bundle and secure the
Fibre Channel cables as directed by the customer.
b. If the switch is installed in an HP-supplied equipment rack, bundle Fibre
Channel cables from the switch and other equipment (groups of 16
maximum), and secure them as directed by the customer.
Installing and Configuring the Edge Switch 2/32
79