Unpack, Inspect, And Install The Switch; Unpack And Inspect The Switch; Desktop Installation - HP storageworks 2/32 Installation Manual

Installing and Configuring the Edge Switch 2/32

Unpack, Inspect, and Install the Switch

This section provides instructions for unpacking and inspecting the Edge
Switch 2/32 and installing it in a desktop or rack-mount configuration.

Unpack and Inspect the Switch

Unpack and inspect the switch:
1. Inspect the shipping containers for damage caused during transit. If a
2. Unpack the shipping containers and inspect each item for damage. Save all
3. If any items are damaged or missing, customers should contact an HP

Desktop Installation

To install and configure the switch on a desktop:
1. Remove the backing from the four adhesive rubber pads and apply the pads to
2. Position the switch on a table or desktop as directed by the customer. Ensure:
3. Verify that all FRUs are installed as ordered.
36
Caution: When you remove the switch from the carton, do not rest it on its
rear window while examining it. To do so may break the FRU handles.
container is damaged, ensure a representative from the freight carrier is
present when the container is opened.
shipping and packing materials. Ensure that all items on the enclosed shipping
list are in each container.
authorized service provider or reseller.
the underside of the switch. Ensure the pads are aligned with the scribed
circles at each corner.
■ Grounded AC electrical outlets are available.
■ Adequate ventilation is present.
■ Areas with excessive heat, dust, or moisture are avoided.
■ All planning considerations are met. Refer to the HP StorageWorks SAN
High Availability Planning Guide.
Edge Switch 2/32 Installation Guide