Configure Network Information - HP storageworks 2/32 Installation Manual

5. Click Activate to save the information. The message Your changes to
6. Set the switch online:

Configure Network Information

Verify the type of LAN installation with the customer's network administrator. If
one switch is installed on a dedicated LAN, network information (IP address,
subnet mask, and gateway address) does not require change. Go to
Switch
If multiple switches are installed, or a public LAN segment is used, network
information must be changed to conform to the customer's LAN addressing
scheme. Perform one of the following:
■
■
Perform the following steps to change a switch IP address, subnet mask, or
gateway address.
1. Choose Configure at the left side of the window. The Configure window
Edge Switch 2/32 Installation Guide
e. Select the Interop mode:
— HP Fabric 1.0. (default). Select this mode if the fabric contains only
HP switches and switches that are operating in HP Fabric 1.0 mode.
— Open Fabric 1.0. Select this mode if the fabric contains HP directors
and switches, as well as other open-fabric compliant switches. Select
this mode for managing heterogeneous fabrics.
the operating parameters configuration have been
successfully activated displays.
a. At the View panel, select Operations at the left side of the panel. The
Operations panel opens with the Switch Beacon page displayed.
b. At the Operations panel, click the Online State tab, then click Set
Online. The message Your operations changes have been
successfully activated displays.
Ports" on page 89.
If network information was changed while performing
Network Information" on page 38, this procedure is not required. Go to
"Configure SNMP Trap Message
If network information was not changed, perform this procedure.
opens with the Ports page displayed.
Using the Embedded Web Server
Recipients" on page 100.
"Configure
"Configure Switch
97