Configure And Enable E-Mail Notification; Configure E-Mail Dialog Box - HP storageworks 2/32 Installation Manual

Configure and Enable E-mail Notification

Perform this procedure to configure and enable e-mail addresses and simple mail
transfer protocol (SMTP) server addresses to receive e-mail notification of switch
(and other managed product) events. The addresses must be configured at the
HAFM application, then enabled. See
instructions on testing this notification feature.
To configure and enable e-mail and SMTP server addresses:
1. At the Product View page, choose Maintenance > Configure E-Mail. The
Figure 22: Configure E-Mail dialog box
2. To enable e-mail transmission to configured addresses, click Enable E-Mail
Note:
Switch 2/32 Product Manager application. E-mail notification can be active for some
switches and inactive for others.
3. Click OK to save the information and close the dialog box.
Edge Switch 2/32 Installation Guide
Configure E-Mail dialog box displays
a. Type the IP address or DNS host name of the SMTP server in the SMTP
Server field. Use 64 alphanumeric characters or less. It is recommended
the IP address be used.
b. For the E-Mail Addresses fields, type the e-mail addresses of up to five
recipients who should be informed of system events. Use 64
alphanumeric characters or less for each entry.
Event Notification. A check mark displays in the box when transmission is
enabled.
The enable function must also be activated for each switch through the Edge
Installing and Configuring the Edge Switch 2/32
"Test Remote Notification" on page 77 for
(Figure 22).
69