Tools and Test Equipment
This section describes tools and test equipment that may be required to install,
test, service, and verify operation of the switch and attached HAFM server.
Tools Supplied with the Switch
The following tools are supplied with the switch. Use of the tools may be required
to perform one or more installation, test, service, or verification tasks. These tools
are supplied with the switch or must be supplied by service personnel.
■
Figure 3: Loopback plug
■
Edge Switch 2/32 Installation Guide
Loopback plug—An SFP multi-mode (shortwave laser) or single-mode
(longwave laser) loopback plug as shown in
port loopback diagnostic tests. One loopback plug is shipped with the switch,
depending on the type of port transceivers installed. Both plugs are shipped if
shortwave laser and longwave laser transceivers are installed.
Fiber-optic protective plug—For safety and port transceiver protection,
fiber-optic protective plugs as shown in
ports without fiber-optic cables attached. The switch is shipped with
protective plugs installed in all ports.
Figure 3
is required to perform
Figure 4
must be inserted in all switch
Introduction
29