Before Filling The Dishwasher With Water; Before Washing With A Potwash Program - Wexiodisk WD-90 DUO Installation And User Manual

Using the dishwasher

4.1.3 Before filling the dishwasher with water

4.1.4 Before washing with a potwash program

Before filling the machine with water prior to the day's work shift, or after a change
of water, a check should be performed to verify the following:
• The machine has been properly cleaned (See "Cleaning the inside of the
machine" on page 44.).
— The strainers have been cleaned.
— The wash arms are not dirty or clogged.
— The water tank has been rinsed out.
— The level sensors in the tank are not dirty.
• Water taps on the water pipe to the machine are open.
• There are enough granules in the machine (See "Checking the amount and
cleaning the granules" on page 46.).
• Granules are only in that part of the tank intended for them.
• There is detergent and drying agent in the relevant dispensers.
• The level pipe (1) is clean and has been correctly fitted, i.e. the rubber
sleeve (3) on the level pipe achieves a good seal with the bottom of the
tank, and the foam separator (2) is clean and not jammed in position.
2
• Cover plates and strainers are correctly fitted.
• The permanent strainer (dividing wall) in the tank has been cleaned.
When washing with a potwash program, you should remember the following:
• Make sure as much food residue as possible is removed from the items to
be washed before putting them in the machine (this will help reduce the
number of times the washing water in the machine will need changing).
• Make sure nothing projects from the washing basket which might catch the
walls of the dishwasher and prevent the basket from rotating.
• Check that the correct wash program has been selected.
WD-90 DUO
1
3
29
Rev. 0 (201401)
25-4-03-005