Water Connection - Wexiodisk WD-90 DUO Installation And User Manual

Installation

Water connection

Hot water (only standard machine) and cold water are connected at (1) and (2),
see figures above. The machine should be connected using steel-braided flexible
hose to allow it to be moved to the side when needed. This is particularly impor-
tant if the machine is positioned in a corner. The hose should have an internal di-
ameter of at least 12 mm. The connections have an external thread. Their
dimensions can be found in "Technical data" on page 57. Both the hot and cold
water connections are fitted with filters.
A shut-off tap must be installed on pipes for incoming water.
Electrical connection
This symbol on a machine component warns of the presence of electrical voltage.
The component in question may only be disconnected by a qualified electrician or
trained personnel.
The machine's wiring diagram contains information on connecting the dishwash-
er. On delivery, the diagram will be lying inside the dishwasher. Keep it safe to
prevent it disappearing or getting destroyed.
The machine must be connected to a lockable mains switch. This should be lo-
cated on a wall, well protected against water and steam emissions. On delivery,
a cable is provided connected to the machine's cable connection (3) for the elec-
trical power supply.
Drain/waste pipe connection
The waste pipe from the machine is connected at (4) and routed to a floor drain.
The waste pipe connected to the dishwasher drain connection should be a corro-
sion-free metal pipe or a PP pipe which can withstand mechanical influences. The
waste pipe is routed to a floor drain with the pipe exit kept clear of the water level.
The recommended dimension of waste pipe and the requirements for floor drain
capacity are stated in "Technical data" on page 57.
WD-90 DUO
14
Rev. 0 (201401)