Installation
3.8 Trial operation
3.8.1 Checklist for start-up
1. Before the machine fills with water, the following must be checked:
•
Water and drain connections
•
The machine should be standing level (See "Installation" on page 11.)
•
The washing basket should allow of easy movement in and out of the
machine
•
Detergent and drying agent
•
The level pipe, cover plates and strainers should be in position
•
The FU42 mini-switch (fuse for tank and booster heater elements) should
be in the OFF position.
•
Check the pump's direction of rotation.
NOTE: If the pump is rotating in the wrong direction, the phase must be
inverted on the terminal block for the incoming electrical cable
•
The right amount of granules should be in the machine
•
The overheating protection for the booster heater and the tank element
should have been reset
2. Filling the machine:
•
Switch on the power to the machine. Press the button for switch-on/switch-
off.
•
Fill the machine with water, see "Filling with water" on page 33.
•
The booster heater fills automatically. Set FU42 to the ON position once
filling of the tank is completed.
•
Bleed the hood cylinder, see "Bleeding the hood cylinder" on page 15.
3. Check the setting of the reference values:
•
Check operation of the booster pump and break tank.
•
Check that the temperatures indicated in the reference values are being
achieved.
•
All the reference values are set to the recommended values on delivery
4. Run a number of washes complete with loads and check that:
•
There are no water leaks
•
The limit switch for the hood operates correctly
•
The hood automatic system operates correctly; i.e. the hood goes up
automatically when a wash program has been run and that it goes up and
down as it should when the hood operating button is pressed
•
The hood's anti-crushing system works correctly, see "Checking the hood's
anti-crushing system" on page 48
•
The water temperatures are maintained
WD-90 DUO
20
Rev. 0 (201401)