Wexiodisk WD-90 DUO Installation And User Manual page 39

Using the dishwasher
The following text is displayed if the last potwash program run was a program
with granules (P1–P3):
NORMAL WASH PX
POTWASH WITH
GRANULES PX
CLOSE THE HOOD
The following text is displayed if the last potwash program run was a program
without granules (P4–P6):
NORMAL WASH PX
POTWASH WITHOUT
GRANULES PX
CLOSE THE HOOD
To start an active program, press the button for operating the hood (9). To start a
program which is not active but which is shown on the display, press the program
selection button for the type of program in question. The hood is then closed using
the operating button (9). If a program other than the ones shown on the display is
to be run, select the program as described below.
During washing, in standby mode, on start-up and switch-off, etc., the status of
the machine is shown in plain text on the display.
It is important that the correct wash program is selected for the type of items in
question.
Normal wash programs
A normal wash program is used for items such as, e.g. glass, crockery and cut-
lery. Three different normal wash programs can be selected with the button (2) by
pressing it once, twice or three times. The selected program is shown on the dis-
play (1).
• Pressing the button once selects normal wash program 1 (P1).
• Pressing the button twice selects normal wash program 2 (P2).
• Pressing the button three times selects normal wash program 3 (P3).
• Pressing the button four times selects program P0, which results in the
machine being set to standby mode for washing.
The difference between the three normal wash programs is the time it takes for
the actual wash cycle to complete. For the total time used by the relevant normal
wash program, see "Technical data" on page 57.
WD-90 DUO
35
Rev. 0 (201401)