Wexiodisk WD-90 DUO Installation And User Manual page 59

Using the dishwasher
ALARM TEXT
(42) TIMEOUT WHEN
FILLING TANK
PRESS RESET TO
START FILLING AGAIN
(105) TIMEOUT WHEN
FILLING BREAK TANK
PRESS RESET TO
START FILLING AGAIN
(43)
TIMEOUT WHEN
HEATING TANK
PRESS RESET
(44)
LOW TEMPERATURE
IN TANK
PRESS RESET
(45) HACCP ALARM
HEATING OF TANK
DEFECT
PRESS RESET
(46) HACCP ALARM
HEATING OF TANK
DEFECT MACHINE
LOCKED CALL SERVICE
(47) LOW TEMP.
BEFORE FINAL RINSE
EXTENDED CHEMICAL
WASH
(48) HACCP ALARM
HEATING OF BOILER
DEFECT
PRESS RESET
(49) HACCP ALARM
HEATING OF BOILER
DEFECT. MACHINE
LOCKED CALL SERVICE
(50) WASHING
DETERGENT ALARM
ACTIVE CHECK
DETERGENT DEVICE
(51) HACCP ALARM
WASHING DETERGENT
FUNCTIONALITY DEFECT
PRESS RESET
(52) HACCP ALARM
WASHING DETERGENT
DEFECT. MACHINE
LOCKED. CALL SERVICE
(65) POWER GUARD
ACTIVATED
PART OF EQUIPMENT
IS TURNED OFF
(57)
EXTERNAL ALARM
ACTIVATED
PRESS RESET
WD-90 DUO
ACTION
Check that water taps connected to the machine are open. Check that the level
pipe is in place and its rubber sleeve achieves a good seal with the tank bottom.
Reset the alarm by pressing the reset button.
Check that water taps connected to the machine are open and there are no prob-
lems on the water supply to the machine. Reset the alarm by pressing the reset
button.
Contact service personnel if the alarm will not go out.
Reset the alarm by pressing the reset button.
Contact service personnel if the alarm will not go out.
Reset the alarm by pressing the reset button.
Contact service personnel if the alarm will not go out.
Reset the alarm by pressing the reset button.
The machine is locked when this alarm is displayed.
Contact service personnel.
Reset the alarm by pressing the reset button.
Check the wash result after the wash cycle has completed, see section "Check
the wash result" on page 38. If the wash result is not acceptable, contact service
personnel.
The alarm can be reset using the reset button, but service personnel should be
contacted as soon as possible.
The machine is locked when this alarm is activated. Contact service personnel.
Check whether the machine is out of detergent. Add detergent.
The alarm can be reset by pressing the reset button.
Contact service personnel or the supplier of the detergent device if the alarm will
not go out.
Check whether the machine is out of detergent. Add detergent.
Reset the alarm by pressing the reset button.
Contact service personnel or the supplier of the detergent device if the alarm will
not go out.
Check whether the machine is out of detergent – add detergent.
Reset the alarm by pressing the reset button.
Contact service personnel or the supplier of the detergent device if the alarm will
not go out.
Information that the power guard has engaged. The text will go out once power
consumption is back within normal limits.
The alarm can be reset by pressing the reset button.
Contact service personnel if the alarm recurs.
55
Rev. 0 (201401)