Wexiodisk WD-90 DUO Installation And User Manual page 49

Using the dishwasher
hood with the button for operating the hood (at the very bottom of the
panel). Wait until the program has completed its cycle and the hood has
opened.
6. Switch off the machine by pressing the button for switch-on/switch-off. The
hood must be open.
7. Remove the cover plates and strainer/granule collection basket.
8. Re. weekly cleaning: Check the amount of granules and clean them as
instructed in the chapter "Checking the amount and cleaning the granules"
on page 46.
9. Clean and rinse off the cover plates and strainer with water. Remove any
detritus which has got stuck in the strainer holes.
10. Unhook the level pipe (1) from its holder and turn it one quarter turn. Leave
it for the moment in the waste pipe. There should now be a slight chink
between the bottom of the tank and the rubber sleeve on the level pipe to
allow the water to run out.
11. Once the tank is empty, remove the level pipe (1), and clean and rinse with
water.
12. Clean the inside of the tank. Clean the permanent strainer (dividing wall) in
the tank.
13. Clean and check that no detritus has got stuck in the level sensors (2) in
the tank.
14. Clean the rinse pipes, see "Checking and cleaning the wash arms" on page
43.
15. Clean the inside of the hood, etc.
WD-90 DUO
45
Rev. 0 (201401)
2
3
1
25-4-03-003