Fluke 2680A User Manual page 54

2680A/2686A
Users Manual
No. Name
A L
B B C
C D E
D F
E G
F
M
2-18
Table 2-1. Front Panel Key Descriptions
Display Monitor Channel. After pressing MON, use the C B keys
to select the desired channel to monitor. Pressing D for down or E
up will start the monitor display automatically scrolling through the
channels. Press MON again to stop the monitor function.
Used to make selections in setup menus and select monitor
channels. The arrow keys have an automatic repeat action.
Used to make selections in setup menus. The arrow keys have an
automatic repeat action when held down for more than 1 second.
Set up communication parameters. To review, just press COMM; to
set, press and hold COMM for 3 seconds until the SET annunciator
lights. If you press COMM again during configuration operations, the
operation cancels. The COMM parameters are as follows:
•
Base Channel Number (01 to 99)
•
Line Frequency (50 or 60 Hz)
•
Ethernet Address (Read Only)
•
RS-232 (Baud Rate)
•
Network
Isolated Network
General Network Socket Port
Internet Protocol (IP) Address
•
Default Gateway
Subnet Mask
Default Gateway Address
Display digital I/O status, relay status, and totalizer count. After
pressing DIO, use the left/right arrow keys to display the DIO status
and the up/down arrow keys to display the totalizer or relay status.
This function is only available if a Digital I/O module is installed in
slot 6.
Displays the PC Card menu. From the menu you can:
•
Load a configuration from the card to the instrument.
•
Store a configuration to the card from the instrument.
•
Erase the card (scan and configuration data).
•
Initialize the card.
•
Get status information about the card memory usage.
A PC Card slot is provided on the 2686A only.
Description