Fluke 2680A User Manual page 273

—T—
TCP/IP protocol stack, H-10
TCP/IP software
Windows, H-10
Test
2-Wire resistance accuracy
FAI module, 4-22
PAI module, 4-21
4-Wire resistance accuracy
FAI module, 4-28
PAI module, 4-24
analog channel integrity, 4-20
dc accuracy test (FAI Module), 4-17
dc accuracy test (PAI Module), 4-16
digital input/output, 4-29
DIO relay/fuse, 4-30
frequency accuracy, 4-19
master alarm output, 4-14
open thermocouple response, 4-20
performance, 4-9
totalizer, 4-31
trigger input, 4-15
trigger output, 4-15
volts AC accuracy test, 4-18
Test setup
initializing the performance, 4-11
Test setup, configuring, 4-9
Testing and troubleshooting, 2-54
Testing the Installation, 2-54
Token ring networks, H-16
Totalizer, 1-12, 2-17
enable, 2-17
Totalizer tests, 4-31
Trend dialog, 3-12
Trigger input, 1-8, 2-8
Trigger input tests, 4-15
Trigger output, 1-8
Trigger output tests, 4-15
Trigger, alarm, 1-10
Trigger, external, 1-9
Trigger, interval, 1-9
Troubleshooting, H-14
Troubleshooting network problems, 2-58
Troubleshooting, testing and, 2-54
True-RMS measurements, C-1
—U—
Universal input module analog
connections, 2-12
Unpacking and inspecting the device, 2-5
Using the Fluke DAQ toolbar, 3-5
UTP cables, G-1
—V—
Variations in the display, 4-35
Viewing the device Ethernet address, 2-44
Volts ac accuracy test, 4-18
Volts dc accuracy test
FAI module, 4-17
PAI module, 4-16
—W—
Waveform comparison (true rms vs average
responding), C-2
Web and alarm mail settings,
configuring, 3-42
WINSOCK DLL and application
programming interface, H-12
Wiring, shielded, 2-15
Index
(continued)
5