Fluke 2680A User Manual page 267

Table I-1 Error Codes (cont.)
Error Code
-1019 WINSOCK.DLL found, but could not be initialized
-2001 During initialization, Toolbox already initialized
-2002 Toolbox not yet initialized
-2003 BCN is not in a valid range (1-99)
-2004 Bad internal Window Toolbox timeout
-2005 Communications already opened for this BCN
-2006 Channel number out of range
-2007 Communications not open to the instrument
-2008 Trying to create a configuration for a BCN that already has a
configuration
-2009 Tried to create more than the maximum number of configurations
-2010 BCN not registered in the CCF
-2011 Out of memory error returned from Toolbox
-2012 CCF doesn't exits or cannot be read
-2013 Cannot create or write the CCF
-2014 BCN cannot be found in the CCF
-2015 Illegal TCP/IP port number
-2016 Invalid model number
-2017 Invalid path provided for loading CCF file
-2018 CCF file damaged or corrupted
-2019 Attempted to set an invalid Network mode
-2020 Network is in General mode and there is no IP address entered for
the instrument
-2021 Model of instrument and model of instrument stored in CCF do not
match
-2022 Requested more than the maximum number of scans
-2023 Bad system time on PC
-2024 The model/version inquiry returned an unknown model number
-2025 Configuration is invalid
RS-232 Commands
Explanation
Appendices
I
I-3