Introduction - Fluke 2680A User Manual

Introduction

Fluke DAQ software provides a graphical user interface (GUI) to the 2680 Series
and NetDAQ data acquisition products. You can use Fluke DAQ software to easily
perform the following:
Fluke DAQ supports the NetDAQ models 2640A and 2645A as well
as the 2680A and 2686A.
•
Configure your 2680 Series network and instrument settings.
•
Download/upload configuration to the instruments.
•
Send commands to and take readings from analog modules and the optional
DIO module.
•
Monitor the instruments' on-line values and alarms.
•
Plot trend charts, and a complete historical capability to retrieve historical
trends, alarms and export data files in .csv format.
•
Record and store scanned data on a PC Card (PCMCIA ATA format in the
2686A).
Removing a PC card while the LED is on may cause a loss
of data. Before removing the card, stop the instrument
scanning.
The material in this section describes the operation of FlukeDAQ
version 2.2.
Note
XWCaution
Note
Using Fluke DAQ Software

Introduction

3
3-3