AGFA DRYSTAR 5302 Technical Documentation Manual page 155

DD+DIS150.05E
SW Installation
on empty HD
The reader should always refer to MedNet to ensure that they are working with the latest copy of the document.
Edition 1, Revision 0
2005-09-09
Machine specific tools, software tools and auxiliary means
(1) Insert the CF card with the printer
"Emergency_Install" software in
the CF card reader
(2) Reboot the printer
(3) At question "Do you want to
preserve config?" select
"NO" in case you want to erase
the complete configuration
"YES" in case want to keep the
current configuration. Refer to
Figure 54 and to info below.
(4) Follow the further instructions on
the local keypad.
(5) Select menu "5 Restore
Configuration" to reload the
previous configuration when
finished.
The printer "Emergency_Install" software can be obtained via MEDNET,
GSO Library.
Caution:
•
Depending on the software patch version it might be possible, that
one of the boards gets re-programmed during the software upgrade.
•
In case this re-programming is interrupted by power loss, this specific
board may become unusable.
•
Do not reboot the printer before requested by a local keypad
message
When you choose during Emergency SW Installation to preserve the
configuration following steps are executed internally:
1. A backup of the printer configuration data is created and copied to
RAM
2. The software is copied from CF card to hard disk and inflated
3. The boards are programmed
4. The backup is restored from RAM
When you choose during Emergency SW Installation not to preserve the
configuration the configuration data are erased. The printer in this case is in
the same state like it has been shipped from factory
(default IP address 169.254.10.10)
Printed copies of this document are not controlled.
Drystar 5302
(Type 5366/100)
Repair and Service
초
2
Figure 55
Chapter 3.2/53
Agfa Company Confidential
5366_Reg01_017_e.cdr