Verifying The Mcu Installation - Avaya scopia elite 6000 series Installation Manual

Performing Initial Configuration
Important:
Using encryption is subject to local regulation. In some countries it is restricted or limited for
usage. For more information, consult your local reseller.
Procedure
1. Access the MCU security settings by selecting Configuration > Setup.
2. Locate the Security section.
3. Select the access level from the Security Mode list (see
Settings on page 74).
protocol status when each security access level is applied.
Table 11: MCU Security Access Levels
Security Access
Level
Standard
High
Maximum
4. Select Apply.
Related links
Performing Initial Configuration

Verifying the MCU Installation

About this task
After you installed the device and performed its initial configuration, you need to verify that it is
installed and configured correctly.
Procedure
1. On the front panel, verify that the power LED is lit green.
February 2016
Table 11: MCU Security Access Levels
Figure 51: Security Access Level Settings
SSH
Enabled
Disabled
Disabled
on page 48
®
Avaya Scopia Elite 6000 Series MCU Installation Guide
Comments on this document? infodev@avaya.com
Figure 51: Security Access Level
on page 74 lists the
FTP
Enabled
Disabled
Disabled
ICMP (ping)
Enabled
Enabled
Disabled
74