Avaya scopia elite 6000 series Installation Manual page 34

Setting up the Device
• Make sure you have the following items, which were shipped with the device and are used to
mount the outer rails to the rack
page 34):
- Two long outer rails
- Two short outer rails
- Two flat-head long screws (Phillips cross recessed flat-head machine screws M5x12mm)
- Two brackets (finishing washers M5)
Procedure
1. Connect the long and short outer rails to each other by sliding the knob on the short rail
through the rounded end of the slot on the long rail
rails on page 35).
February 2016
(Figure 11: Preparing the parts required to mount the rails
Figure 11: Preparing the parts required to mount the rails
®
Avaya Scopia Elite 6000 Series MCU Installation Guide
Comments on this document? infodev@avaya.com
(Figure 12: Connecting the two outer
on
34