Avaya scopia elite 6000 series Installation Manual page 32

Setting up the Device
• If there are few devices mounted in the rack, find the lowest possible location to mount the
device, to ensure the rack remains stable.
4. Make sure you have the following items, which were shipped with the device and are used to
mount the rails to the rack
page 33):
• Two long outer rails and two short outer rails, to be attached to the rack itself (as
described in
• Two inner rail extensions, used to attach the device to the outer rails on the rack (as
described in
• Eight flat-head long screws (Phillips cross recessed flat-head machine screws M5x12mm).
You need only four to mount the device.
• Eight brackets (finishing washers M5). You need only four to mount the device.
• Two flat-head short screws (Phillips cross recessed flat-head machine screws 6-32
UNCx3/16")
February 2016
Figure 9: One rack unit of space on the rack
(Figure 10: Preparing the parts required to mount the rails
Mounting the Outer Rails on to the Rack
Mounting the Device on to the Outer Rails
®
Avaya Scopia Elite 6000 Series MCU Installation Guide
Comments on this document? infodev@avaya.com
on page 33)
on page 37)
on
32