Avaya scopia elite 6000 series Installation Manual page 35

2. Attach the rails to the rack posts, at the location you marked in
for Mounting the Device
a. Starting at the rear of the rack, attach the short rail by aligning the two square knobs
with the rack holes
page 35).
The rails are spring-loaded and lock into place on the rack with a safety latch.
b. Slide the long rail towards the front of the rack, adjusting the length according to the
depth of the rack. Attach it to the front of the rack as you did to the rear of the rack.
Important:
To unfasten the rail pins from the rack, push the safety latch to release:
February 2016
Figure 12: Connecting the two outer rails
on page 30:
(Figure 13: Attaching the short rail to the rear of the rack
Figure 13: Attaching the short rail to the rear of the rack
®
Avaya Scopia Elite 6000 Series MCU Installation Guide
Comments on this document? infodev@avaya.com
Mounting the Device on to the Rack
Preparing the Rack and Rails
on
35