Avaya scopia elite 6000 series Installation Manual page 58

Performing Initial Configuration
6. Configure the IP addresses of each interface
network interface
Table 9: Configuring the IP addresses of each network interface
Field
Management IP address
Management router
Management subnet mask
Media/Signaling IP address
Media/Signaling router
Media/Signaling subnet mask
7. Select Apply at the bottom of the page.
8. Select Yes to restart the MCU.
9. Connect the network cable of the media subnet cable to the right ethernet port (NIC2). See
Figure 35: The device's media and signaling connections
February 2016
Figure 34: Configuring IP separation with two network connections
on page 58).
®
Avaya Scopia Elite 6000 Series MCU Installation Guide
Comments on this document? infodev@avaya.com
(Table 9: Configuring the IP addresses of each
Description
IP address of the MCU management interface
(left ethernet port) as configured via serial port.
This is the IP used to access this web interface.
IP address of the management subnet router
IP address of the management subnet mask
IP address of the MCU media and signaling
interface (right ethernet port belonging to a
different subnet)
IP address of the media and signaling subnet
router
IP address of the media and signaling subnet
mask
on page 59.
58