Configuring Sip Server Settings - Avaya scopia elite 6000 series Installation Manual

Performing Initial Configuration
The default port is 1719.
6. Select Apply.
7. Log in to the MCU Administrator web interface.
8. Locate the Status Map section.
9. Verify the MCU is connected to the Ethernet.
10. Verify the MCU is connected to the Gatekeeper.
Related links
Configuring Network Protocols for the MCU

Configuring SIP Server Settings

About this task
You can configure settings for SIP server profiles which set how the MCU and the registrar interact.
Depending on connection types supported by the SIP server, MCU supports these transport
connection types for sending messages to SIP server:
• UDP
• TCP
• TLS
Procedure
1. Select Configuration
2. Select Protocols.
3. Select Enable SIP protocol to enable MCU communication with the SIP server.
February 2016
Figure 39: The Status Map showing the gatekeeper connection
on page 60
.
®
Avaya Scopia Elite 6000 Series MCU Installation Guide
Comments on this document? infodev@avaya.com
62