Avaya scopia elite 6000 series Installation Manual page 44

Setting up the Device
2. Connect the device serial port to a PC with the terminal emulator software installed.
3. Start the terminal emulation application on the PC.
4. Set the communication settings in the terminal emulation application on the PC as follows
(Table 6: Configuring the communication settings
Table 6: Configuring the communication settings
Field Name
Baud Rate
Data bits
Parity
Stop bits
Flow Control
5. Power the device (see
Verify the power LED is lit green
February 2016
Figure 24: Rear panel of the device
Figure 25: Device front panel
(Figure 25: Device front panel
®
Avaya Scopia Elite 6000 Series MCU Installation Guide
Comments on this document? infodev@avaya.com
on page 44):
Value
9600
8
None
1
None
on page 45).
on page 45).
44