Enabling Gvrp Compatibility - HP 3100 Series Configuration Manual

To configure MRP timers:
Step
Enter system view.
1.
Enter interface view.
2.
Configure the LeaveAll timer.
3.
Configure the Join timer.
4.
Configure the Leave timer.
5.
Configure the Periodic timer.
6.
Table 28 shows the value ranges for Join, Leave, and LeaveAll timers and their dependencies.
•
If you set a timer to a value beyond the allowed value range, your configuration will fail. To do
that, you can change the allowed value range by tuning the value of another related timer.
•
To restore the default settings of the timers, restore the Join timer first, followed by the Leave
and LeaveAll timers.
Table 28 Dependencies of the Join, Leave, and LeaveAll timers
Timer
Join
Leave
LeaveAll
NOTE:
You can restore the Periodic timer to the default at any time.

Enabling GVRP compatibility

MVRP can be compatible with GVRP. When the peer device supports GVRP, you can enable GVRP
compatibility on the local end, so that the local end can receive and send MVRP and GVRP protocol
packets at the same time.
Command
system-view
•
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
mrp timer leaveall timer-value
mrp timer join timer-value
mrp timer leave timer-value
mrp timer periodic timer-value
Lower limit
20 centiseconds
Twice the Join timer
Leave timer on each port
198
Remarks
N/A
Use one of the commands.
Optional.
The default setting is 1000
centiseconds.
Optional.
The default setting is 20
centiseconds.
Optional.
The default setting is 60
centiseconds.
Optional.
The default setting is 100
centiseconds.
Upper limit
Half the Leave timer
LeaveAll timer
32760 centiseconds