Configuring The Customer-Side Port; Configuring The Network-Side Port; Vlan Mapping Configuration Examples; One-To-One Vlan Mapping Configuration Example - HP 3100 Series Configuration Manual

Step
Return to system view.
5.
Create a QoS policy and enter QoS
6.
policy view.
Map the CVLANs to the SVLAN by
7.
associating the class with the
behavior.

Configuring the customer-side port

Step
Enter system view.
1.
Enter Ethernet interface
2.
view.
Configure the port as a trunk
3.
port.
Assign the port to CVLANs
4.
and SVLANs.
Apply the uplink policy to the
5.
incoming traffic.

Configuring the network-side port

Step
Enter system view.
1.
Enter Ethernet interface
2.
view.
Configure the port as a trunk
3.
port.
Assign the port to CVLANs
4.
and SVLANs.

VLAN mapping configuration examples

One-to-one VLAN mapping configuration example

Network requirements
As shown in
•
Each home is offered PC, VoD, and VoIP services, and connects to a wiring-closet switch
through the home gateway.
•
To meet the service provider's network design, assign a specific VLAN for each type of traffic
(PC, VoD, or VoIP traffic) from each home on the wiring-closet switch.
Command
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
qos apply policy policy-name
inbound
Command
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
Figure 61:
Command
quit
qos policy policy-name
classifier tcl-name behavior behavior-name mode
dot1q-tag-manipulation
171
Remarks
N/A
N/A
The default link type of an
Ethernet port is access.
By default, a trunk port belongs to
VLAN 1 only.
N/A
Remarks
N/A
N/A
The default link type of an
Ethernet port is access.
By default, a trunk port belongs to
VLAN 1 only.