HP 3100 Series Configuration Manual page 198

<SwitchB> system-view
[SwitchB] lldp enable
# Enable LLDP on Ethernet1/0/1. By default, LLDP is enabled on ports.
[SwitchB] interface ethernet 1/0/1
[SwitchB-Ethernet1/0/1] lldp enable
# Set the LLDP operating mode to Tx.
[SwitchB-Ethernet1/0/1] lldp admin-status tx
[SwitchB-Ethernet1/0/1] quit
Verifying the configuration:
# Verify the following items:
•
Ethernet 1/0/1 of Switch A connects to an MED device.
•
Ethernet 1/0/2 of Switch A connects to a non-MED device.
•
Both ports operate in Rx mode, and they can receive LLDP frames but cannot send LLDP
frames.
[SwitchA] display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 2
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,4 minutes,40 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [Ethernet1/0/1]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors:
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV : 0
Port 2 [Ethernet1/0/2]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors:
Number of MED neighbors
Number of CDP neighbors
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Rx_Only
: No
: 0s
1
: 1
: 0
: 0
: Enable
: Rx_Only
: No
: 0s
1
: 0
: 0
189