Configuring The Mvrp Registration Mode; Configuring Mrp Timers - HP 3100 Series Configuration Manual

Step
Enable MVRP globally.
2.
Enter interface view.
3.
Configure the port to permit
4.
the specified VLANs.
Enable MVRP on the port.
5.

Configuring the MVRP registration mode

Step
Enter system view.
1.
Enter interface view.
2.
Configure the MVRP
3.
registration mode.

Configuring MRP timers

CAUTION:
The MRP timers apply to all MRP applications, for example, MVRP, on a port. To avoid frequent
VLAN registrations and deregistrations, use the same MRP timers throughout the network.
Each port maintains its own Periodic, Join, and LeaveAll timers, and each attribute of a port
maintains a Leave timer.
Command
mvrp global enable
•
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
port trunk permit vlan { vlan-list
| all }
mvrp enable
Command
system-view
•
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
mvrp registration { fixed |
forbidden | normal }
197
Remarks
By default, MVRP is globally
disabled.
To enable MVRP on a port, first
enable MVRP globally.
Use one of the commands.
By default, a trunk port permits
only VLAN 1.
Make sure that the trunk port
permits all registered VLANs.
For more information about the
port trunk permit vlan
command, see Layer 2 —
Switching Command Reference.
By default, MVRP is disabled on a
port.
Remarks
N/A
Use one of the commands.
Optional.
The default setting is normal
registration mode.
LAN