61
63
6.9.4 Installing/adjusting the tip-assist
The tip-assist can be installed on the accessory mount in the installation position provided (see fig. 65, item 1).
1) Press the spring on the tip-assist (see fig. 65, item 2).
2) Insert the tip-assist into the accessory mount (see fig. 65, item 1).
3) Allow the spring to lock in.
65
6.10 Installing and adjusting the safety belt
Depending upon the fitting situation and the settings, the safety belt can be installed on the lower securing point on
the back plate (see fig. 67, item 1) or on the topmost free securing point on the slider (see fig. 67, item 2).
1) Fasten the safety belt to the securing points with the supplied mounting screws.
2) Tighten the mounting screws to 7 Nm.
3) Adjust the safety belt. Information on the settings can be found in the manufacturer's instructions for use
accompanying each product.
Ventus
62
64
Settings
Ottobock | 29