Adım 3 Print the Graphics
Print the graphic and the marks with your printer
When printing on a roll media, make sure the orientation as following:
Adım 4 Load the printout onto cutter
The Origin Mark is is different from the rest registration marks. Please make sure the
media is fed with correct direction.
Adım 5 Cut the Contour
Send out the command from software to perform the contour cutting job.
5.6
Tips for AAS
For getting better results of contour cutting, there are some tips below for your reference.
Keep light sources simple and avoid illuminating from the sides of cutter.
Before operating AAS, change the maximum paper size in ValueCut driver property.
STEP 1 Find the ValueCut model in the "Printer & Fax" folder of your PC.
Automatic Aligning System
(Scaling = 100%).
5-9
ValueCut Kullanım Kılavuzu