Table of Contents
Advertisement
Initial Setup
4. Enter the IP address or URL for the NTP server.
Please enter an ntp server ip address or leave blank and
press Enter:
5. Enter a name for the storage volume.
Please enter a storage volume name (e.g., storage01):
storage01
Important
This step will create a RAID5 (15 physical drives with a hot spare drive) on each RAID box
and JBOD. Each multipath device is built on top of a RAID logical drive over two Fibre
Channel paths, and used as a storage volume. Therefore, two devices are displayed over
the Fibre Channel paths. That is, two devices are displayed for a single target (RAID logical
drive) in the "iSCSI/FC Disks" table of Hosts\<host IP>\Storage web page. This is normal.
6. Now create (or join) the cluster, and finish the settings for the cluster.
•
Create or Join cluster
•
Name the cluster
•
Replication number (see below)
Please enter "create" or "join" a
cluster(e.g., create): create
Please enter a cluster name
(e.g., mycluster01): mycluster01
Please enter a replication number
(between 1 to 3) of object data(e.g.,
2): 2
xxx.xxx.xxx.xxx
23
Promise Technology, Inc.
Advertisement
Table of Contents
