Testing Recorder Outputs - GE Moisture monitor series 3 Programming Manual

Testing Recorder Outputs

Programming with PanaView
1. To test the recorder outputs, click on the
"Recorder Properties" window (Figure 4-4 on page 4-6). A
message appears: "This will suspend Recorder #[X] on Channel
[X]. Are you sure you want to test this recorder?" Click on
continue.
2. The "Test Recorder" window appears, as shown in Figure 4-5
below. At the top, slide the pointer to the desired percentage of the
full scale recorder range, and click on
3. To trim the recorder outputs, scroll the arrows to the right of the
"Zero" and "Span" windows up or down until you reach the
desired values, and click on
Note: For a complete discussion of testing and trimming recorder
outputs, refer to the sections Testing the Recorder Outputs and
Trimming the Recorder Outputs in Chapter 2 of the Service
Manual.
The screen returns to the "Recorder Properties" window.
Figure 4-5: Recorder Test Window
[Test]
button shown in the
[OK]
.
[OK]
.
March 2008
[OK]
to
4-7