GE Moisture monitor series 3 Programming Manual page 74

March 2008
Entering Auxiliary Input
Curve Data (cont.)
3-46
You may now do one of the following:
•
Enter data for a different channel or type of sensor by pressing the
[NO]
key until you reach the Programming Menu, and then refer to
Entering Calibration Data for New Probes/Sensors on page 3-39.
•
Refer to another section and perform a different procedure. Refer
to Figure 3-2 on page 3-48 and Figure 3-3 on page 3-49 to navigate
through the user program.
•
[RUN]
Exit by pressing the
IMPORTANT:
You must configure a channel AND enter the
necessary calibration data in order for a sensor to
work properly.
key.
Advanced Programming