GE Moisture monitor series 3 Programming Manual page 95

GE Infrastructure
Sensing
We,
as the manufacturer, declare under our sole responsibility that the product
to which this document relates, in accordance with the provisions of ATEX Directive 94/9/EC Annex II, meets the
following specifications:
Furthermore, the following additional requirements and specifications apply to the product:
• Having been designed in accordance with EN 50014 and EN 50020, the product meets the fault tolerance
requirements of electrical apparatus for category "ia".
• The product is an electrical apparatus and must be installed in the hazardous area in accordance with the
requirements of the EC Type Examination Certificate. The installation must be carried out in accordance with all
appropriate international, national and local standard codes and practices and site regulations for flameproof
apparatus and in accordance with the instructions contained in the manual. Access to the circuitry must not be
made during operation.
• Only trained, competent personnel may install, operate and maintain the equipment.
• The product has been designed so that the protection afforded will not be reduced due to the effects of corrosion
of materials, electrical conductivity, impact strength, aging resistance or the effects of temperature variations.
• The product cannot be repaired by the user; it must be replaced by an equivalent certified product. Repairs should
only be carried out by the manufacturer or by an approved repairer.
• The product must not be subjected to mechanical or thermal stresses in excess of those permitted in the
certification documentation and the instruction manual.
• The product contains no exposed parts which produce surface temperature infrared, electromagnetic ionizing, or
non-electrical dangers.
GE Infrastructure Sensing, Inc.
1100 Technology Park Drive
Billerica, MA 01821-4111
Moisture Monitor Series 3 Analyzer
II 1 G EEx ia IIC (-20°C to +50°C)
BAS01ATEX7097
1180
ATEX COMPLIANCE
U.S.A.
CERT-ATEX-D (Rev. August 2004)