March 2008
Changing Measurement
Modes and Units (cont.)
4-2
To change meter programming:
1. Click on the window to be changed. The selected window turns
red.
2. Click on the desired meter on the network tree on the left of the
programming window. The tree expands to show a list of available
sensors.
a. Click on the desired sensor, and the tree expands further to
show a list of available units.
b. Double-click on the unit, and the MMS-3 reassigns the selected
box, on the MMS-3 and on the Matrix Display screen.
c. To unassign a mode and unit without assigning a different
sensor, click on the desired window and then on
Figure 4-1: The Meter Display Window
[Unassign].
Programming with PanaView