GE Moisture monitor series 3 Programming Manual page 47

Setting up a Log (cont.)
Advanced Programming
Sel. DATA LOG Mode
[O] H T P Aux1
Table 3-5: Measurement Modes
Display Abbreviation
O
H
T
P
Aux 1
Aux 2
User*
VREF
GND
*User functions are available only through PanaView
software (see Programming User Functions in Chapter 4).
Datalog HYGRO Unit
[DP/°C] DP°F
Note: The number of measurement choices and the units of
measurement vary depending on the measurement mode
selected.
Finished (YES/NO)?
Start Logging?
Press [YES] or [NO]
1
Use the arrow keys to move to
the desired measurement mode
[YES]
and press . See Table 3-5
below for a list of available
measurement modes
Measurement Mode
Oxygen
Hygrometry
Temperature
Pressure
Auxiliary 1
Auxiliary 2
User Function
Volt Reference
Signal Ground
1
Use arrow keys to move the
brackets to the desired units and
[YES]
press .
If you press [NO], the menu
returns to the "Enter Log#"
prompt. Repeat the preceding
steps to select the remaining
measurements you want to log
(up to 12). When you have
finished entering items and
[YES]
parameters, press
[YES]
Press to begin logging, or
[NO]
to leave the menu without
logging.
March 2008
.
.
3-19