Reconfiguring A Channel For A New Sensor - GE Moisture monitor series 3 Programming Manual

Reconfiguring a Channel
for a New Sensor
Advanced Programming
If you decide to connect a different type of sensor to one of the
channels of your unit, you must reconfigure that channel. For
example, if you are using a moisture probe on channel 1 and later
decide to connect an oxygen cell, you must "tell" (reconfigure) the
MMS-3 that you have changed the sensor.
Note: If you are using a probe capable of multiple inputs (e.g., TF
probe) or using more than one input (including a constant),
you must configure the channel to measure all the possible
inputs. Refer to the Multiple Input Instructions highlighted in
this procedure.
Note: If you are already in the System Menu, proceed to the
Measurement Mode step.
[PROG]
Press the key to enter the user program.
Enter Passcode: XXXX
Be sure the number displayed in the upper right-hand corner of the
screen is the channel you want to program. If not, press the
key to select the desired channel.
Programming Menu
[SYSTEM] AUTOCAL
Measurement Mode
O [H] T P Aux1
Table 3-9: Measurement Modes
Display Abbreviation
O
H
T
P
AUX1
AUX2
CNST-PPMV
.
Enter the passcode
1 Use the arrow keys to move the
brackets to SYSTEM and press
[YES].
1 Select the desired measurement
mode and press [YES]. See
Table 3-9 below for a list of
available measurement modes.
Measurement Mode
Oxygen
Hygrometry
Temperature
Pressure
Auxiliary 1
Auxiliary 2
PPMv Multiplication Factor
March 2008
[CHAN]
3-35