GE Moisture monitor series 3 Programming Manual page 82

Changing Measurement
Modes and Units (cont.)
Programming with PanaView
Figure 4-2 below shows a typical change on the PC screen from
O2/ppm (shown in Figure 4-1 on page 4-2) to PSIg.
Note: For an explanation of unit abbreviations, see the
Measurement Modes and Units table in Chapter 2.
3. Click
[Apply]
to apply the change immediately and continue
programming, and
window.
Note: To return the window to its previous settings, click on the
[Cancel]
button instead of the
Figure 4-2: Matrix Display After Programming
[OK]
to confirm the change and close the
[OK]
button.
March 2008
4-3