Setting Up The Recorders - GE Moisture monitor series 3 Programming Manual

March 2008

Setting Up the Recorders

3-4
The MMS-3 has two recorder outputs (A and B) for each channel.
IMPORTANT:
Switch Blocks must be set to the appropriate
positions for output ranges (see Setting the Switch
Blocks in Chapter 1 of the Service Manual).
[PROG]
Press the key to enter the user program.
Enter Passcode: XXXX
Note: If you have already entered the user program, see Figure 3-3
on page 3-49 to navigate to the Recorder Menu.
Programming Menu
[RECORDERS]
Be sure the number displayed in the upper right-hand corner of the
screen is the channel you want to program. If not, press the
key to select the desired channel.
Select Recorders
[A] B
Select RCD Range
[0-20mA] 4-20mA
Select Mode
O [H] T P Aux1
Enter the passcode
1 Use the arrow keys to move the
brackets to RECORDER and
[YES]
press .
1 Use the arrow keys to move the
brackets to the desired recorder
[YES]
and press .
1 Use the arrow keys to move the
brackets to the desired recorder
[YES]
range and press
1 Use the arrow keys to move to
the desired measurement mode
and press [YES]. See Table 3-2 on
page 3-5 for a list of available
measurement modes.
Advanced Programming
.
[CHAN]
.