GE Moisture monitor series 3 Programming Manual page 30

March 2008
Setting Up the Alarms
(cont.)
3-2
Table 3-1: Measurement Modes
Display Abbreviation
O
H
T
P
Aux 1
Aux 2
User*
Vref
Gnd
*User functions are available only through PanaView
software (see Programming User Functions in Chapter 4).
Select Unit
[DP/°C] DP/ °F
Note: The number of measurement choices and the units of
measurement vary depending on the measurement mode
selected.
Select Trip Type
[Above] Below
A Setpoint DeadBD
+0.0 +0.0
Measurement Mode
Oxygen
Hygrometry
Temperature
Pressure
Auxiliary 1
Auxiliary 2
User Function
Volt Reference
Signal Ground
1
Use arrow keys to move the
brackets to the desired units and
[YES].
press
1 Use the arrow keys to move the
brackets to the desired trip type
(whether you want the alarm to
trip above or below the
programmed value) and press
[YES].
1
Use the numeric keys to enter the
setpoint (the value above or
below which you want the alarm
to trip) and press [YES] to
confirm the entry. If you wish to
enter a deadband value
(explained on the next page),
press the right arrow key to reach
the value, use the numeric keys
to enter the value, and press
[YES].
Advanced Programming