March 2008
Reconfiguring a Channel
for a New Sensor (cont.)
3-38
Table 3-11: Probe Types and Configurations
Probe Type
N/A
Oxygen
% (Percent)
ppmv (Parts per Million by Volume)
N/A
TF (Three-Function Probe)
Hygrometry
Mxx (M Series Probe)
Kh (Constant Dew Point)
N/A
TF (Three-Function Probe)
Temperature
Mxx (M-Series)
Kt (Constant Temperature)
N/A
TF (Three-Function Probe)
X1 (Auxiliary 1)
Pressure
X2 (Auxiliary 2)
Kp (Constant Pressure)
N/A
Auxiliary 1
I (Current)
V (Voltage)
N/A
Auxiliary 2
I (Current)
V (Voltage)
You can now do one of the following:
•
Configure the other channel by pressing
Programming Menu. Then select the desired channel and repeat
the procedure.
•
Enter calibration data by pressing
Programming Menu. Then refer to Entering Calibration Data for
New Probes/Sensors on page 3-39.
•
Refer to another section and perform a different procedure. Refer
to Figure 3-2 on page 3-48 and Figure 3-3 on page 3-49 to navigate
through the user program.
•
[RUN]
Exit by pressing
IMPORTANT:
You must configure a channel AND enter the
necessary calibration data for a sensor to work
properly.
Configurations
[NO]
until you return to the
[NO]
until you reach the
.
Advanced Programming