Set Datamatrix Parameters - CognitiveTPG A799II Programming Manual

Set DataMatrix Parameters

ASCII
GS ( k pL pH cn fn m d1 d2
Hexadecimal
1D 28 6B 05 00 36 42 m d1 d2
Decimal 29 40 107 5 0 54 66 m d1 d2
Value and Ranges:
Value: Ranges:
(pL + pH x 256) 5
cn 54
fn 66
m 0, 1, 48, 49
d1, d2 (when m = 0, 48) (0, 0), (10, 10), (12, 12), (14, 14), (16, 16), (18, 18), (20,20), (22, 22), (24, 24), (26, 26), (32, 32), (36, 36),
(40, 40), (44, 44), (48, 48), (52, 52), (64, 64), (72, 72), (80, 80), (88, 88), (96, 96), (104, 104), (120, 120),
(132, 132), (144, 144)
d1, d2 (when m = 1, 49) (8, 0), (8, 18), (8, 32), (12, 0), (12, 26), (12, 36), (16, 0), (16, 36), (16, 48)
Defaults: m = 0
d1, d2 = (0, 0)
This command sets the symbol type, number of rows (d1), and number of columns (d2)
Module (minimum unit of symbol)
m d1, d2
0, 48 (0, 0)
0, 48 Other than (0, 0)
1, 49 (8, 0), (12, 0), (16, 0)
1, 49 Other than (8, 0),
(12, 0), (16, 0)
Notes
This command is ignored if any of m, d1, or d2 is outside its range.
Settings of this command are in effect until 1b 40 is executed, the printer is reset, or the power is turned off.
Settings of this command affect the encode processing for DataMatrix. Changing the symbol type affects the horizontal and
vertical sizes of the symbol.
d2
symbol type number of rows, columns
Square (ECC200) Sets automatic processing for the number of rows and columns of
the symbol.
Square (ECC200) Sets the number of rows of the symbol to d1, the number of
columns to d2.
Rectangle (ECC200) Sets the rows of the symbol to d1, the number of columns to
automatic processing.
Rectangle (ECC200) Sets the number of rows of the symbol to d1, the number of
columns to d2.
A799-2PG0001B 4/2016
Chapter 4: Programming Commands
d1
117