Set Interpretation Of "Set Current Color" Command - CognitiveTPG A799II Programming Manual

42 Chapter 4: Programming Commands
Related information
An incorrect setting of n for a two-color paper or failure to set n when a two-color paper is loaded will result in poor
output quality.
The following list clarifies how the A799II printer will behave in each emulation mode:
Two-color paper and ColorPOS
• If the paper type is changed using the 0x1D 0x81 command, the font and default lines per inch (LPI) will be setup as in
the table below.
• If only the font is changed, the default LPI will automatically be changed as in the table below.
• If emulation is switched to LEGACY, Native or A793/A794 emulation(s), the paper type will automatically be changed
to monochrome paper, and the font and LPI will be changed as in the table below.
• If emulation is switched from any emulation to Native, the font and LPI will remain unchanged because Native mode
supports all font and LPI options offered in the emulation modes.
• The "Set Default LPI" option in the configuration menu is not offered in LEGACY emulation mode. The LPI is set at
6.00.
Font and lines per inch (LPI) setup for different emulations
Emulation LPI
Mode Options
Native 6.00, 6.77, 7.52, 8.13 Standard
A793/A794 6.00, 7.52, 8.13
emulation
LEGACY 6.00
emulation

Set interpretation of "Set current color" command

ASCII US ETX SYN ENQ n
Hexadecimal
1F 03 16 05 n
Decimal
31 03 22 05 n
Value of n: 0-FF (Hex)
n = 01 will cause 1B 72 01 to print red. Any other value for 1B 72 will print black.
n = 00 will cause 1B 72 00 to print red and all other values to print black.
This command defines how to interpret the 1B 72 command for legacy environments. It provides a method to resolve any
differences in the definition of command 1B 72 between the Native mode and earlier implementations in other printers.
In Native mode, the standard "Set current color" command should be used.
Related information
The 1F 03 16 00 command disables this and all other LogoEZ
To disable one LogoEZ feature when multiple LogoEZ
®
enable only those you desire.
commands and features are supported only in Native mode.
®
Font(s) Font
Options Size
13x24
Tall 13x27
ColorPOS 13x27
®
Paper-saving 13x18
Standard 13x24
Tall 13x27
Standard 13x24
features are set, first disable all LogoEZ
®
A799-2PG0001B 4/2016
Default Default Comments
LPI EDR
7.52 3 Default setup for monochrome paper
6.77 3
6.77 3 Default setup for two-color paper
10.15 3
7.52 3
6.00 7 Default setup for Escape Commands
6.00 10
features.
®
features and then re-
®