CognitiveTPG A799II Programming Manual page 84

84 Chapter 4: Programming Commands
The margin message printing feature is activated after the header logo after a restart at each knife-cut. Note that
when printing graphic objects, merging is turned off by each knife cut. No correlation exists (when both are set)
between watermark and logo skip distances.
If the f = 4 logo link is undefined, you should set a null trailer logo with s = 1 and p = 144 (1F 03 16 04 1 90, no logo
at index F3). This will turn off margin message at the position of a knife cut and leave a clear space at the top of the
next receipt.
f = 4 link logo print before cut
Prints a logo after the skip distance of "s" before a logo and "p" past a logo and performs a knife cut (1F 03 16 04 s
p).
Immediately before executing a knife-cut command, if s > 0, execute the following:
• skip (feed paper) "s" dot rows (15 s command)
• stop background merging (1D 9B 1 command). Save previous background merging value, so logo prints in the
clear
• set centered justification (1B 61 1 command), saving the previous justification
• if a logo at index F3h is currently defined, print the logo by sending print downloaded bit image, normal size (1D
2F 0 command), without changing the value of current logo.
• reset justification to previous value (1B 61 [previous value])
• skip (feed paper) "p" dot rows (15 p command) a minimum value of 90h, to ensure knife cut occurs after the logo
• restore background merge suspension (1D 9B [previous value])
Related information
This command is utilized in the LogoEZ
colorization setup without requiring any application changes. The default setup was designed to provide a general level of
colorization features that would not affect the printer operation. You can expand beyond the default features of the utility
by modifying the application at the host. However, do not attempt to modify the settings within the utility.
LogoEZ utility default settings:
®
f = 1: s = 1H
a = 30H
f = 2: s = 32H
r = 19H
f = 3: s = 1H
r = 7H
t = 1H
f = 4: s = 30H
a = A0H
utility. The utility can be used to pre-configure new printers with a default
®
A799-2PG0001B 4/2016