Miscellaneous Configuration Commands; Set Diagnostics Mode; Enable Or Disable Knife; Enable Or Disable Paper Low Sensor - CognitiveTPG A799II Programming Manual

142 Chapter 4: Programming Commands

Miscellaneous configuration commands

Set diagnostics mode

ASCII US EXT NUL n
Hexadecimal 1F 03 00 n
Decimal 31 03 00 n
Value of n:
0 = Normal operation/diagnostics mode off
1 = DataScope mode (without graphics)
2 = Receipt test mode
6 = DataScope mode (with graphics)
Default: 0 (Normal operation)
Sets the diagnostics mode to DataScope mode (with or without graphics) or receipt test mode, or sets the printer back to
normal operation. See "Diagnostics modes" in chapter two for more information.

Enable or disable knife

ASCII US EXT STX n
Hexadecimal 1F 03 02 n
Decimal 31 03 02 n
Value of n:
0 = Disable
1 = Enable
Default:
1 (Enable)
Enables or disables the knife.

Enable or disable paper low sensor

ASCII
US EXT EXT n
Hexadecimal 1F 03 03 n
Decimal 31 03 03 n
Value of n:
0 = Disable
1 = Enable
Default: 1 (Enable)
Enables or disables the paper low sensor. The printer will not be able to sense when the paper roll is low if this is set to
disabled.

Set max power

ASCII US EXT EOT n
Hexadecimal
1F 03 04 n
Decimal
31 03 04 n
Value of n: 0 = Auto
1 = Level I (55W)
2 = Level II (75W)
3 = Level III (90W)
Default:
0 (Auto)
Sets the max power to match the power supply of the printer.
A799-2PG0001B 4/2016